This shows you the differences between two versions of the page.
Next revision Both sides next revision | |||
mounting [2014/05/23 09:23] pstras created |
mounting [2014/06/14 19:38] pstras |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | Mounting | + | ====== Mounting ====== |
+ | |||
+ | First tighten Panda board to the bottom board by 4 screw. Also tighten voltage converter. | ||
+ | (Zdjęcie przykręconej pandy i konwertera do dolnej płyty) | ||
+ | |||
+ | Next glue logic level converter and voltage pins to the bottom board in place like in the picture. | ||
+ | (Zdjęcie z zaznaczonymi czerwoną obwódką konwerterem oraz pinami) | ||
+ | |||
+ | Now glue Low Voltage Level Signaller to the front face. | ||
+ | (Zdjęcie z przyklejonym sygnalizatorem napięcia) | ||
+ | |||
+ | In right face mount switch and RGB Diode. | ||
+ | (Zdjęcie zamontowanej diody i przełącznika w w bocznej ściance) | ||
+ | |||
+ | Tighten electric drives to left and right face. | ||
+ | (Zdjęcie z przykręconymi silnikami) | ||
+ | |||
+ | Connect all cables. (Look picture below) | ||
+ | (Schemat połączeń) | ||
+ | |||
+ | Tighten Roboclows together. Next mount to the front face. | ||
+ | (Zdjęcię skręconych Roboclów oraz przykręconych do przedniej ściany) | ||
+ | |||
+ | Next tighten faces and bottom board together. | ||
+ | (Zdjęcie skręconego bez górnej pokrywy) | ||
+ | |||
+ | Mount USB hub to the left face like on the picture below. Connect hub to the Panda board. | ||
+ | (Zdjęcie pokazujące huba mieszczącego się nad baterią) | ||
+ | |||
+ | Finally tighten top board to the rest. | ||
+ | (Zdjęcie złożonego) |