First tighten Panda board to the bottom board by 4 screw. Also tighten voltage converter.
Next glue logic level converter and voltage pins to the bottom board in place like in the picture.
Now glue Low Voltage Level Signaller to the front face.
In right face mount switch and RGB Diode.
Tighten electric drives to left and right face.
Connect all cables. (Look picture below)
Tighten Roboclows together. Next mount to the front face.
Mount USB hub to the left face like on the picture below. Connect hub to the Panda board.
Finally tighten top board to the rest.
