This shows you the differences between two versions of the page.
body [2014/06/30 23:03] pstras |
body [2015/08/08 00:43] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Preparing Body ====== | ||
- | ===== Bottom board ===== | ||
- | |||
- | Take bottom board, and drill 4 holes diameter 4mm for Panda Board and 2 holes for voltage converter. Also glue converter DC/DC and "voltage pins". Holes and gluing places are arranged like below. | ||
- | |||
- | ===== Faces ===== | ||
- | |||
- | Take right face of casing and drill hole diameter 12mm for main switch (see the image). Next mount switch and RGB diode. | ||
- | |||
- | ===== Body mounting ===== | ||
- | |||
- | Now screw right, left, front, back faces and bottom board together. | ||
- | |||
- | {{:skrecone_scianki.jpg?nolink&200|}} |