This shows you the differences between two versions of the page.
|
mounting [2014/06/30 23:07] pstras |
mounting [2015/08/08 00:43] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Mounting ====== | ||
| - | |||
| - | First tighten Panda board to the bottom board by 4 screw. Also tighten voltage converter. | ||
| - | |||
| - | {{:przykrecona_panda.jpg?nolink&200|}} | ||
| - | |||
| - | Next glue logic level converter and voltage pins to the bottom board in place like in the picture. | ||
| - | |||
| - | Now glue Low Voltage Level Signaller to the front face. | ||
| - | |||
| - | {{:sygnalizator.jpg?nolink&200|}} | ||
| - | |||
| - | In right face mount switch and RGB Diode. | ||
| - | |||
| - | Tighten electric drives to left and right face. | ||
| - | |||
| - | {{:przykrecone_silniki.jpg?nolink&200|}} | ||
| - | |||
| - | Connect all cables. (Look picture below) | ||
| - | |||
| - | {{:polaczenia.png?nolink&200|}} | ||
| - | |||
| - | Tighten Roboclows together. Next mount to the front face. | ||
| - | |||
| - | {{:roboclow_y.jpg?nolink&200|}} | ||
| - | |||
| - | Mount USB hub to the left face like on the picture below. Connect hub to the Panda board. | ||
| - | |||
| - | {{:usb_hub.jpg?nolink&200|}} | ||
| - | |||
| - | Finally tighten top board to the rest. | ||
| - | |||
