====== Mounting ======

First tighten Panda board to the bottom board by 4 screw. Also tighten voltage converter.

{{:przykrecona_panda.jpg?nolink&200|}}

Next glue logic level converter and voltage pins to the bottom board in place like in the picture.

Now glue Low Voltage Level Signaller to the front face.

{{:sygnalizator.jpg?nolink&200|}}

In right face mount switch and RGB Diode.

Tighten electric drives to left and right face.

{{:przykrecone_silniki.jpg?nolink&200|}}

Connect all cables. (Look picture below)

{{:polaczenia.png?nolink&200|}}

Tighten Roboclows together. Next mount to the front face.

{{:roboclow_y.jpg?nolink&200|}}

Mount USB hub to the left face like on the picture below. Connect hub to the Panda board.

{{:usb_hub.jpg?nolink&200|}}

Finally tighten top board to the rest.