This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
mounting [2014/05/23 09:23] pstras created |
mounting [2015/08/08 00:43] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | Mounting | + | ====== Mounting ====== |
+ | |||
+ | First tighten Panda board to the bottom board by 4 screw. Also tighten voltage converter. | ||
+ | |||
+ | {{:przykrecona_panda.jpg?nolink&200|}} | ||
+ | |||
+ | Next glue logic level converter and voltage pins to the bottom board in place like in the picture. | ||
+ | |||
+ | Now glue Low Voltage Level Signaller to the front face. | ||
+ | |||
+ | {{:sygnalizator.jpg?nolink&200|}} | ||
+ | |||
+ | In right face mount switch and RGB Diode. | ||
+ | |||
+ | Tighten electric drives to left and right face. | ||
+ | |||
+ | {{:przykrecone_silniki.jpg?nolink&200|}} | ||
+ | |||
+ | Connect all cables. (Look picture below) | ||
+ | |||
+ | {{:polaczenia.png?nolink&200|}} | ||
+ | |||
+ | Tighten Roboclows together. Next mount to the front face. | ||
+ | |||
+ | {{:roboclow_y.jpg?nolink&200|}} | ||
+ | |||
+ | Mount USB hub to the left face like on the picture below. Connect hub to the Panda board. | ||
+ | |||
+ | {{:usb_hub.jpg?nolink&200|}} | ||
+ | |||
+ | Finally tighten top board to the rest. | ||
+ |